Insert bearings should not operate at speeds above the limiting speed listed in the product table. This speed limit is set by the seal design.
For insert bearings with grub screws or an eccentric locking collar, the permissible speed is also influenced by the shaft tolerance. Where using these bearings on shafts with tolerances other than h6, compare the speed values listed in the product table with those in table 1. The lower value is the permissible speed.
- outer ring temperature ≤ 60 °C (140 °F)
- ambient temperature ≤ 25 °C (80 °F)
- very light to moderate loads (P ≤ 0,05 C)
- cast iron housing