Cookies on the SKF website

We use cookies to ensure that we give you the best experience on our websites and web applications. By continuing without changing your browser settings, we assume you give your consent to receive cookies. However, you can change your browser cookie setting at any time.

Grease life for capped bearings

Grease life for capped bearings should be estimated according to the procedure described in this section. The grease life for capped bearings is presented as L10, i.e. the time period at the end of which 90% of the bearings are still reliably lubricated. The method to estimate relubrication intervals (→ Relubrication intervals) represents the L01 grease life and should not be used.
The grease life for capped bearings depends on the operating temperature and the speed factor. It can be obtained from the diagrams. Diagram 1 is valid for standard deep groove ball bearings. The grease performance factor (GPF) is listed in table 1. Diagram 2 is valid for SKF Energy Efficient deep groove ball bearings.
The grease life for each is valid under the following operating conditions:
  • horizontal shaft
  • inner ring rotation
  • light load (P ≤ 0,05 C)
  • operating temperature within the green temperature zone of the grease (table 1)
  • stationary machine
  • low vibration levels
If the operating conditions differ, the grease life obtained from the diagrams has to be adjusted:
  • For vertical shafts, use 50% of the value from the diagram.
  • For heavier loads (P > 0,05 C), use the reduction factor listed in table 2.
SKF logo