Cookies on the SKF website

We use cookies to ensure that we give you the best experience on our websites and web applications. By continuing without changing your browser settings, we assume you give your consent to receive cookies. However, you can change your browser cookie setting at any time.

Selecting lubricating oils

Selecting oil is primarily based on the viscosity required to form a sufficiently thick hydrodynamic film at normal operating temperature. The viscosity of oil is temperature dependent, becoming lower as the temperature rises. The viscosity-temperature relationship of an oil is characterized by the viscosity index (VI). For rolling bearings, oils with a viscosity index of at least 95 (little change with temperature) are recommended.
To form a sufficiently thick oil film in the contact area between the rolling elements and raceways, the oil must retain a minimum viscosity at normal operating temperature. The rated viscosity ν1 required at normal operating temperature to provide adequate lubrication can be determined from diagram 1, provided a mineral oil is used. When the operating temperature is known from experience or can otherwise be determined, the corresponding viscosity at the internationally standardized reference temperature of 40 °C (105 °F), i.e. the oil ISO VG viscosity class, can be obtained from diagram 2, which is compiled for a viscosity index of 95.
Certain bearing types, such as spherical roller bearings, toroidal roller bearings, tapered roller bearings, and spherical roller thrust bearings, typically have a higher operating temperature than other bearing types such as ball bearings and cylindrical roller bearings, under comparable operating conditions.
When selecting an oil, consider the following:
  • Bearing life may be extended by selecting an oil where the viscosity n at normal operating temperature is higher than the obtained viscosity ν1 (diagram 1). The condition ν > ν1 can be obtained by choosing a mineral oil with a higher ISO VG viscosity class or by selecting an oil with a higher viscosity index, provided the oil has the same pressure-viscosity coefficient. Since higher viscosity increases operating temperature, there is frequently a practical limit to the lubrication improvement that can be obtained using this method.
  • If the viscosity ratio κ < 1 (→ Viscosity ratio κ), SKF recommends using an oil containing EP additives. If κ < 0,4 an oil with EP additives must be used. Oils with EP additives may also enhance operational reliability in cases where κ > 1 and medium and large-size roller bearings are used. It should be remembered that some EP additives may cause adverse effects.
  • For exceptionally low or high speeds, for critical loading conditions, or for unusual lubricating conditions, contact the SKF application engineering service.


A bearing with a bore diameter d = 340 mm and an outside diameter D = 420 mm is required to rotate at a speed ν = 500 r/min. What is the required viscosity ν at the reference temperature of 40 °C (105 °F)?
From diagram 1 with dm = 0,5 (340 + 420) = 380 mm and n = 500 r/min, the rated viscosity ν1 required for adequate lubrication at normal operating temperature is approximately 11 mm2/s. From diagram 2, assuming that the normal operating temperature is 70 °C (160 °F), a lubricating oil in the ISO VG 32 viscosity class, with an actual viscosity ν ≥ 32 mm2/s at the reference temperature of 40 °C (105 °F), is required.
SKF logo