Cookies on the SKF website

We use cookies to ensure that we give you the best experience on our websites and web applications. By continuing without changing your browser settings, we assume you give your consent to receive cookies. However, you can change your browser cookie setting at any time.

Bearing data

Needle roller / angular contact ball bearings
Dimension standardsBoundary dimensions: ISO 15 – dimension series 59, except for following inner ring parameters in the NKIB 59 series:
  • extended width on one side
  • slightly larger bore diameter of the narrow part
Tolerances

For additional information → Tolerances

Normal, except for width of the complete inner ring in the

NKIB 59 series: 0/–0,3 mm
Values: ISO 492 (table 1)

Internal clearanceNormal (bearings with an inner ring)

Check availability of C2, C3 or C4 clearance classes


Values: ISO 5753-1 (table 2)

Values are valid for unmounted bearings under zero measuring load.

Permissible misalignmentMisalignment increases bearing noise and reduces bearing service life.
Needle roller / thrust ball bearings
Dimension standardsBoundary dimensions: DIN 5429-1,
except for:
  • NX and NX .. Z series bearings (not standardized)
Tolerances

For additional
information
→ Tolerances

  • D: Normal
  • Fw: F6 (table 3)
  • d: E8 (table 3)
  • C: 0/–0,25 mm
  • C1 (applicable to NKX series only): 0/–0,2 mm

Values:
  • Radial bearings → ISO 492 (table 1)
  • Thrust bearings → ISO 199 (table 4)
Operating clearanceBearings without an inner ring

Range slightly less than Normal if recommended tolerances (table 5) applied

Permissible misalignmentCannot tolerate any misalignment.
Needle roller / cylindrical roller thrust bearings
Dimension standardsBoundary dimensions: DIN 5429-1
Tolerances

For additional information

→ Tolerances

  • D: Normal
  • Fw: F6 (table 3)
  • d: E8 (table 3)
  • C: 0/–0,25 mm
  • C1: 0/–0,2 mm

Values:
  • Radial bearings → ISO 492 (table 1)
  • Thrust bearings → ISO 199 (table 4)
Operating clearanceBearings without an inner ring

Range slightly less than Normal if recommended tolerances (table 5) applied

Permissible misalignmentCannot tolerate any misalignment.
SKF logo